spindle motor meaning in English
主轴电动机
主轴马达
Examples
- General specification for d . c . spindle motors
数控机床直流主轴电动机.通用技术条件 - General specification for a . c . spindle motors
数控机床交流主轴电动机.通用技术条件 - Nevertheless , “ spindle motors will probably always be there ” to turn mini - disk drives , even denser ones that store video files , says bi chao , research scientist at the data storage institute in singapore
但正如新加坡资料储存研究院的赵毕（音译）所说，为转动小型磁碟驱动器，主轴马达可能永远都不会消失，即使是在资料储存密度更高的影音磁碟亦然。 - The results show that , when increasing the feed rate of the grinding wheel , decreasing the rotating speed of the wafer chuck table and using coarser grit grinding wheel , the material removal rate in the wafer rotating grinding increase , the feed rate of the grinding wheel has greater influence on the material removal rate ; when suitably increasing the rotating speed of the grinding wheel , decreasing the feed rate of the grinding wheel and using finer grit grinding wheel , the wafer surface roughness can be reduced ; there exists a critical rotating speed of the grinding wheel ( about 2300rpm ) , beyond which the material removal rate evidently decreases and the spindle motor current and wafer surface roughness steeply increase ; when the grit size of the grinding wheel is finer than # 2000 , the material removal rate decreases and the wafer surface roughness has no obvious improvement
研究结果表明，增大砂轮轴向进给速度和减小工件转速，采用粗粒度砂轮有利于提高磨削矽片的材料去除率，砂轮轴向进给速度对材料去除率的影响最为显著；适当增大砂轮转速，减小砂轮轴向进给速度，采用细粒度砂轮可以减小磨削表面粗糙度；在其它条件一定的情况下，砂轮速度超过一定值会导致材料去除率减小，主轴电机电流急剧增大，表面粗糙度变差；采用比# 2000粒度更细的砂轮磨削时，材料去除率减小，矽片表面粗糙度没有明显改善。 - By using a wafer - rotating grinding machine , the influence of the main process factors including grit size of diamond grinding wheel , rotating speed of the wafer chuck table , rotating speed and the down feed rate of the cup grinding wheel on the material removal rate , spindle motor current and wafer surface roughness in grinding large size wafer are experimentally investigated
摘要利用基于自旋转磨削原理的矽片超精密磨床，通过试验研究了砂轮粒度、砂轮转速、工件转速及砂轮进给速度等主要因素对材料去除率、砂轮主轴电机电流以及磨削后矽片表面粗糙度的影响关系。